top of page

Mains Multiplier 5



  • 'Star-wired' phase, neutral and earth for best performance

  • Protects all five contacts by the Pulse Protector inside

  • IEC C13 input connector gives the freedom to use preferred power cord

  • Two HF filtered output sockets

Watch our 'How It's made' of the Mains Multiplier 5.

We pride ourselves on attention to detail throughout the entire product development. 
How It's Made Mains Multiplier 5 - Essential Audio Tools

What to expect?


An improvement in dynamics, a much better sound image and a lower hum level. The sound character of your audio system remains, fortunately!


By using the Mains Multiplier with integrated Pulse Protector your equipment has less trouble with electrical failures induced by distortion on your network, and it is better protected against damage through lightning impact nearby. A guarantee that lightning impacts will not damage your devices can not be given because the energy-content is too high.

Where to use?


Wherever you need to connect multiple loads to the mains, a Mains Multiplier is a wise choice. Of course you will have to use high performance power cords, else a Mains Multiplier will not perform at its best. It's a combination of factors, only if you use a Mains Multiplier in combination with high performance power cords you will have the maximum results for your audio system.


Of course it is possible to use a Mains Multiplier as an ordinary multiple socket without high performance power cords, but this will not give you optimal results. Our advice is to upgrade to our power cords, the result will be rewarding.

Working principle


The Mains Multiplier 5 is not a regular multiple socket, more a work of art made on a CNC machine that shapes this form out of one piece of synthetic material. Yes… synthetic! The results speak for themselves, optical as well as electrical.


The type of the five sockets is chosen because of the high contact pressure, which is obvious when putting in or pulling out a power plug. More contact pressure and an optimal contact surface do create a low resistance value which is very important for a good power distribution

The wiring from phase, neutral and earth is connected by a star principle. Every output has its own wiring towards the input connector. Peaks in the current or interference signals that appear on the earth contacts of one socket will now have less effect on the other sockets.


Just behind the IEC input connector a Pulse Protector is integrated. This prevents peaks and pulses to reach your equipment. For more information, read about the Pulse Protector elsewhere on this site. Two outputs are fitted with internal high frequency filters which contribute to a natural sound and detailed image.

This multiplier is more than enough for most systems. But if you are looking for something really impressive, take a look at our flagship, the Filtered Multiplier 8.




Maximum voltage:

Maximum peak voltage:

Maximum peak current:

Maximum peak energy:

Response time:

Maximum continuous current per socket:

Maximum total current:




Phase-Neutral, Phase-Earth

and Neutral-Earth

250 Volt

2500 Volt

4500 Ampere

3x65 Joule

<25 nanoseconds

10 Ampere

10 Ampere

350(l) x 70(w) x 59.5(h) in mm



The Mains Multiplier 5 is supplied without a power cord. It will work with every power cord with an IEC plug C13, as found on most audio equipment.

However, to make you benefit from all the Mains Multiplier 5 qualities you need to connect to the mains supply with a Current Conductor L.

Here you can download the manual for the Mains Multiplier 5, 7 and 8:  manual mm5 /7/8.pdf

bottom of page